Where is the reset button of mit Netgear RP614v2?

I don't have a RP614 but my WGR614 has it snugly below the antennae. It is a round hole surrounded by square holes.

Are they trying to tell us something here??

On the RP614 the round hole is near the top end of the RJ45 sockets. i.e at the end away from the power cable. You can't miss it. You have to use a paper clip that is open out and insert into the hole.

Happy hunting!

I believe on the router, you will see a VERY small hole within 1/2 inch of the power connector on the right side rear, you will need to use a PIN with that model, not a writing pen, something smaller, maybe like a paper clip. (FROM NETGEAR)>> To restore the factory default configuration settings without knowing the administration password or IP address, you must use the Default Reset button on the rear panel of the router. 1. Press and hold the Default Reset button until the Test LED turns on (about 10 seconds).

2. Release the Default Reset button and wait for the router to reboot.

Netgear Rp614v2

This should be located on the rear panel close to where the power cord is. It is not a button persay, as it does not stick out. You need to use a pen or something of that nature, push it into the hole and count to 3. While holding it in the lights should not blink or be on. When you release the pressure from the pen in the whole, you should see the lights blink showing it re-making the connections.

should be in the back, but you've to look closely...you may have to use the tip of a pen to press it in ...