Cole

I am planning on getting 72 inch aquarium. Is it better to have my reef tank a little taller or a little deeper?

Which filter should I use for my 75 gallon disus aquarium. The Ehiem Pro 4+ Canister Filter - 350 or the Eheim Classic Canister Filter with Media - 2215 I know a sump is probaly better but I don't have the room.

I am setting uo a 20 gallon saltwater aquarium. Which canister filter should I use? The fluval 106 (up to 25 gal) or the fluval 206 (up to 45 gal)

I have a 56 gallon column tank I am setting up for discus. Which style of filter (external canister or sump filter) is best for a discus aquarium? If a sump what size of tank should I use for the sump?

I jus add 2 more 2 x 4 gig memory sticks to my computer. They are the same as the ones that were originally in the computer so I know they are compatible. The problem is that when I press the power button the tower starts but my monitor stays black(as if it were off) and goes from HDMI to analog to HDMI to analog and repeats. Can someone please help me figure out what is wrong.

I have stretched my polyester fleece and applied polyester resin. I followed the directions for the resin and hardener to the letter. It has been 2 days and the resin is still really tacky. What went wrong?

I have 2 angel fish, 4 raspberry tetras, 2 lyretail mollies, 3 Bristle nose plecos, and 1 cory catfish. I want to know if a pair or German Blue Rams will be compatible with my fish....... The aquarium is not an issue ( 90 gallon tank, with lots of living plants and other hiding spots)

I'm looking for some auto insurance companies in canada that will insure show vehicles. I live in Alberta. I know that not all insurance companies won't insure show vehicles.

I have a 2003 chevy 1500. The truck idles fine. once in gear and i take my foot off the gas the rpms drop and the engine stalls. I have replaced the fuel filter and the iac but the problem is still occurring. What else could be causing this to happen?

I have a 2003 chevy 1500 with a 4.8 Vortec V8. The engine idles fine whenin park. When i shift from park to either drive or reverse the rpm drops and the engine stalls. could carbon build up in the throttle body cause this.

I have a 2003 chevy 1500. I did the big 3 upgrade on it. The truck starts fine. The problem is that when i shift from park to either drive or reverse, the rpm drops really low and the truck stalls. What could be causing this?

I have a 2003 chev silverado 1500 with a 4.8 V*8. When i start my truck it runs fine but when i shift out of park and into either reverse or drive the rpm drops and the truck stalls. what could be causing this?

I havea 2003 chevy silverado 1500. I did the big 3 upgrade on it and now it won't start.

The wiring is 0/1 awg and is as follows: Battery Neg to Chasis (point of connection on frame is

almost directly below battery)

Battery neg to point on engine (bolt is on the alternator

bracket that u use when boosting

the battery)

Battery positive to alternator

All points that the gound goes to have been ground down to bare metal. I have checked that all connection points are tight (no loose connections). I have replaced the starter and the starter relay.

I have checked the battery with multimeter and it reads 12.67

When I turn the key i get the ticking from the starter but the engine won't turn over. Any advice as to what my problem may be.

I am running 0/1 awg from my auxiliary battery into a spliter. There will be two 4 gauge wires the run from the splitter, with each wire going to a capactior. From the cap each 4 guage wire goes into a slpitter, with 2 more4 guage running to amps. Where should i put my fuses?

I installed a stage 3 Airaid intake on my 2003 chevy 1500. It starts fine, but when i put it into gear my rpm drops and then the engine stalls. What's wrong.

I have a 2003 chevy 1500 that i recently added a second battery and an isolator to. The way the battery system is set up is: Main battery in stock location under hood

Battery isolator is mounted under the hood on passengers side

Second battery is located in truck box

I'm not 100% sure where to put the fuses and on which wires. Where do i put the fuses?

(all the wire for the batteries is 1/0 awg)

Where can I buy 1/0 awg or 2/0 awg wire in Edmonton?

Can I safely hook up two amps to a single capacitor?

Use an algebraic method to determine the values of x where the graphs y = -0.5 and y = cos 2x intersect, where -pi =< x =< pi Please show all your work and use exact values.